Wall Mounting Matted and Framed Photography
The final step to displaying great photography involves mounting it on your walls. While this sounds very simple, it may seem to be intimidating to people new to photography, and those who do not consider themselves do-it-yourself-ers. Actually, the process is fairly simple with a few tools. While there are extensive, many different ways to artistically display photography we will give attention to the more basic approach of single line of images across a wall.
First, let’s discuss tools. Most of the time you can get away with a tape measure, a sludge hammer, a few small nails and a screw motorist. My personal recommendation is to acquire a progressing tool, as well as a long metal ruler. You may desire a recording measure so as to calculate distances between your photographs and of course to assure that spacing is proportional. A hammer will of course be necessary to drive the nails into the drywall.
A electric screwdriver may be necessary, if your frames do not possess increasing hardware already attached. Within many cases, store acquired frames will include a little comb looking hanger, which will require a little Phillips screwdriver to attach to the frame. As I actually mentioned one minute ago, it is a good idea to acquire a level, if you expect to hold photography more than once. A laser beam lever is a great tool for a home owner, as it will produce noticeable straight lines across your walls, which can make a snap that you can measure to mount frames EzeFrame.
If you start shopping for one, make sure that it has some sort of a wall mount, which will not damage the walls, but will attach securely. There are many different models out there, with a little research and brand comparison, you will find a good tool, which will make you thank me for indicating it.
Let’s get started out. First of all, determine how many photographs you are going to install and whether or not the wall is very long to accommodate all of them. Obviously, if the total width of your framed photographs is more than the length of the wall structure end to end, you will have to reconsider the number of photographs to be mounted. Measure your wall, end to finish, in order to get the total length, and split that length into fifty percent.
This will give you the middle of the wall. Right now place a mark anywhere that middle actually is. Spot a mark with a pencil at approximately your eye-level. Do not worry, pencil erases easily. Today figure out how many photographs will be to the left and also to the right of this mark. Remember, you may choose to use this mark for one of your photographs, or else you may choose to leave it bare.
Now figure out how high you want your photographs. Try to keep them at eye-level. Measure from top of the threshold to in which the top of the picture frame will be. Now, measure from the top of the frame to the wall mount on that framework. Add the first number to this and you should have the height at which you will be driving in your small nails. Record this number.
Now that you know how high the photographs will be mounted, and the intervals between them, it is time to mark all details which will get a toenail. If you have a laser level, you are in luck. Just place it at either conclusion of the wall at the same height as you recorded earlier. The laser level will project a straight line to the other end of the wall structure, and you will have a reference line. Right now from the middle of the walls move in either path and put a mark where the nails will go. This distance was determined earlier. This distance will be equal from one mark to the next. All marks will be done on the guide line from your laser beam level. Once all factors are marked, hammer a tiny nail, on a downwards angle to create a simple hook at every mark.